Reverse Engineered Object : Rendered and Exploded

 

 Reverse Engineered Object : Rendered and Exploded


Finally! I have managed to complete my Reverse Engineered Object! 
There was so many complications during the final steps but I managed to push through!

Here are some photos of the final product : 






Comments

Post a Comment

Popular posts from this blog

Reverse Engineered Object : Progress 1

Image
 Reverse Engineered Object : Progress 1 The Object that I have chosen to reverse engineer from my three options, Is my Muji balance mechanical pencil. I chose this object because even if it seems quite simple, there are still a lot of different intricate parts and textures areas. I first started this project by sketching out the pencil and its parts to measure each piece.  It was annoying at first that when I would measure something and remeasure it again I would get very different results in numbers.  Although I do know these are the things that have to be done to be accurate! There are still quite a lot of parts that I need sketch and measure out in the inner parts of the pencil. This is because many of them are very small and hard to see, and as well I am not sure how the "screws" or "spirals" are done in Rhino so I will be waiting for the tutorial on it in class.  Here is my progress so far :  This part of the pencil has a texture outer side that I will stil...
Read more

Outsourced Wearable Object: Concept Selection and Proof Sheet

Image
  Outsourced Wearable Object: Concept Selection and Proof Sheet After wonderful conversations with my peers and Bryan, I have finally concluded to the THREE ring concepts I enjoy the most.   A Bonsai, a Snake and a Flower ring.  Honestly this was pretty hard. I had a lot of troubles on different parts for each ring. Although I tried not to stress about it since i knew this was also a rough draft. Here are some ScreenShots of my work : (I always forget to take shots of my process) The snake seems like a simple enough concept but I've been having troubles with the shape after i SWEEP it. Not only that I haven't been able to fully complete the reptile scale texture since I've been having troubles with the FLowAlongSrf I had to learn how to make a Petal of a flower by using InterpretCRV, and learning how to use the REBUILD tool.  I haven't completed the Bonsai tree yet, I finally got a decent shape to the trunk and i'm still planning to manipulate it with Twist and ...
Read more