Milestone 1: 2D Surface Design Study - Part 1

Milestone 1: 2D Surface Design Study - Part 1

The first Milestone project in Object Design with Bryan Cera is learning more about 2D surface study. The first research to be done is to go out into the world (or our own homes) to find 10 or more different patterns, and designs..

Here are my photos: 

- Keyboard rest, Weaved plant pot, Heat pack, Pillow case, Pocky wrapper, Wallpaper, Clothing pattern from a skirt and a dress, and three washi tapes.





 





When I started doing my drawings I first started sketching the designs and patterns I found interesting from the photos and then I attempted to brainstorm to create my own designs. 


I'm really into the more nature-like and more flowing designs.







 

Comments

Post a Comment

Popular posts from this blog

Reverse Engineered Object : Progress 1

Image
 Reverse Engineered Object : Progress 1 The Object that I have chosen to reverse engineer from my three options, Is my Muji balance mechanical pencil. I chose this object because even if it seems quite simple, there are still a lot of different intricate parts and textures areas. I first started this project by sketching out the pencil and its parts to measure each piece.  It was annoying at first that when I would measure something and remeasure it again I would get very different results in numbers.  Although I do know these are the things that have to be done to be accurate! There are still quite a lot of parts that I need sketch and measure out in the inner parts of the pencil. This is because many of them are very small and hard to see, and as well I am not sure how the "screws" or "spirals" are done in Rhino so I will be waiting for the tutorial on it in class.  Here is my progress so far :  This part of the pencil has a texture outer side that I will stil...
Read more

Outsourced Wearable Object: Concept Selection and Proof Sheet

Image
  Outsourced Wearable Object: Concept Selection and Proof Sheet After wonderful conversations with my peers and Bryan, I have finally concluded to the THREE ring concepts I enjoy the most.   A Bonsai, a Snake and a Flower ring.  Honestly this was pretty hard. I had a lot of troubles on different parts for each ring. Although I tried not to stress about it since i knew this was also a rough draft. Here are some ScreenShots of my work : (I always forget to take shots of my process) The snake seems like a simple enough concept but I've been having troubles with the shape after i SWEEP it. Not only that I haven't been able to fully complete the reptile scale texture since I've been having troubles with the FLowAlongSrf I had to learn how to make a Petal of a flower by using InterpretCRV, and learning how to use the REBUILD tool.  I haven't completed the Bonsai tree yet, I finally got a decent shape to the trunk and i'm still planning to manipulate it with Twist and ...
Read more