Technical drawings : Advance

This next assignment is meant for us to practice building objects in 3D. Wel learnt that it is easier if you start by building on a 2D surface to be then extruded into 3D. 

We learned a few new tools and commands like Chamfer, Boolean ( Boolean Split, Boolean Difference, Boolean Union), revolve axis and merge face. 

These new commands will be very helpful into this next project.


Some of the objects were quite simple to break down and understand how it can be created, other object on the other hand were a little more difficult to figure out how to start them, but eventually I figured it out :)

Here are my results :











And here are the objects in rendered view :)
   

Comments

Post a Comment

Popular posts from this blog

Reverse Engineered Object : Progress 1

Image
 Reverse Engineered Object : Progress 1 The Object that I have chosen to reverse engineer from my three options, Is my Muji balance mechanical pencil. I chose this object because even if it seems quite simple, there are still a lot of different intricate parts and textures areas. I first started this project by sketching out the pencil and its parts to measure each piece.  It was annoying at first that when I would measure something and remeasure it again I would get very different results in numbers.  Although I do know these are the things that have to be done to be accurate! There are still quite a lot of parts that I need sketch and measure out in the inner parts of the pencil. This is because many of them are very small and hard to see, and as well I am not sure how the "screws" or "spirals" are done in Rhino so I will be waiting for the tutorial on it in class.  Here is my progress so far :  This part of the pencil has a texture outer side that I will stil...
Read more

Outsourced Wearable Object: Concept Selection and Proof Sheet

Image
  Outsourced Wearable Object: Concept Selection and Proof Sheet After wonderful conversations with my peers and Bryan, I have finally concluded to the THREE ring concepts I enjoy the most.   A Bonsai, a Snake and a Flower ring.  Honestly this was pretty hard. I had a lot of troubles on different parts for each ring. Although I tried not to stress about it since i knew this was also a rough draft. Here are some ScreenShots of my work : (I always forget to take shots of my process) The snake seems like a simple enough concept but I've been having troubles with the shape after i SWEEP it. Not only that I haven't been able to fully complete the reptile scale texture since I've been having troubles with the FLowAlongSrf I had to learn how to make a Petal of a flower by using InterpretCRV, and learning how to use the REBUILD tool.  I haven't completed the Bonsai tree yet, I finally got a decent shape to the trunk and i'm still planning to manipulate it with Twist and ...
Read more